Tools and blanks

Spare Parts  |  Tools and blanks

Pocket weather forecaster... Ref: 1003970  


Price: £10.15 (Excluding VAT at 17.5%)

Pocket weather forecaster, available in inches or millibars

An essential tool... Ref: 1003980  


Price: £223.39 (Excluding VAT at 17.5%)

An essential tool designed to hold down the large spring on aneroid capsules whilst removing or replacing the holding pin. An invaluable aid to the aneroid repairer, adaptable for different sizes. For use in jaws of an existing vice.

A very handy additional vice... Ref: 1003990  

A very handy additional vice to use in jaws of an existing vice. This enables you to sand, polish and work on small and thin pieces of brass by raising and lowering jaws to suit thickness of material being held

Hygrometer or level blanks... Ref: 1005000  


Price: £30.64 (Excluding VAT at 17.5%)

Hygrometer or level blanks, 1 7/8" i/d, 2 5/8" o/d x 1/2" thick

Hygrometer or level blanks... Ref: 1005010  


Price: £30.64 (Excluding VAT at 17.5%)

Hygrometer or level blanks, 2 1/16" i/d, 2 7/8" o/d x 3/8" thick

Cast blank... Ref: 1005210  


Price: £11.42 (Excluding VAT at 17.5%)

Cast blank, 6" x 1/2"

Cast blank... Ref: 1005220  


Price: £28.08 (Excluding VAT at 17.5%)

Cast blank, 6" x 3/4"

Cast blank... Ref: 1005230  


Price: £34.47 (Excluding VAT at 17.5%)

Cast blank, 6" x 7/8"

Cast blank... Ref: 1005240  


Price: £48.51 (Excluding VAT at 17.5%)

Cast blank, 5" x 1 1/4"

Cast brass blank... Ref: 1005260  


Price: £36.95 (Excluding VAT at 17.5%)

Cast brass blank 1" diameter, 6" long

Diamond glass cutter Ref: 1003991  


Price: £44.04 (Excluding VAT at 17.5%)

A traditional, and we consider hard to find (well ones that work well are!) hand held glass cutter, each diamond is individually set and can normally be re set when worn at a lower cost than buying a new one. Used in the correct manner can cut 5 miles of glass. These are designed for approx 2mm thick glass and will often cut 1mm up to 3 mm if thicker glass required then a heavier diamond is required with a different angle for best results. Once you have used (and mastered) the diamond cutter you will probably never wish to use any other type of glass cutter. We have been using them for years in our workshop and are delighted with them , unlike those we once tried from japan which were next to useless! We suggest you buy a few of these while they are still available - stocks will not last many years we fear.

Spare Parts  |  Tools and blanks